◆Performance specifications

Models				NEX80
Specification item			Unit	5E			9E(Standard)			12E
Injection	Screw diameter		mm	A 22	B 22	BB 28	AA 26	A 28	B 32	AA 28	A 32	B 36
	Injection capacity		cm3	35	35	57	59	69	90	77	101	127
	Plasticization capacity(PS)		kg/h	16	16	32	19	28	40	28	40	54
	Max. injection pressure		MPa [kgf/cm2]	255 [2600]	210 [2140]	169 [1725]	265 [2700]	243 [2480]	186 [1900]	265 [2700]	223 [2280]	176 [1800]
	Injection rate	Standard	cm3/s	190	265	308	159	185	241	166	217	275
		High velocity	cm3/s
		High load	cm3/s	133	186	216	127	148	193	135	177	224
	Injection velocity	Standard	mm/s	500			300			270
		High velocity	mm/s
		High load	mm/s	350			240			220
	Screw velocity		rpm	0〜350			0〜300			0〜300
	Hopper capacity(Optional)		L	15			25			25
Clamping	Clamping force		kN[tf]	784[80]			784[80]			784[80]
	Clamping stroke		mm	300			300			300
	Mold thickness(min.-max.)		mm	200〜385			200〜385			200〜385
	Max. daylight opening		mm	685			685			685
	Tie bar clearance(HxV)		mm	420x420			420x420			420x420
	Die plate dimensions(HxV)		mm	580x580			580x580			580x580
	Min. mold dimensions(HxV)		mm	295x295			295x295			295x295
	Locating ring diameter		mm	100			100			100
	Ejector stroke		mm	75			75			75
Others	Heater band capacity		kW	4.96	5.73	6.16	7.22	8.36	9.26	7.98	9.13
	Machine dimensions(LxWxH)		m	4.00x1.12 x1.68			4.11x1.12 x1.68	4.19x1.12 x1.68	4.27x1.12 x1.68	4.16x1.12 x1.68	4.33x1.12 x1.68
	Floor dimensions(LxW)		m	3.58x0.75			3.58x0.75			3.58x0.75
	Machine weight		t	3.5			3.7			3.7

• Actual plasticizing capacity may vary, depending on the molding conditions and material used.
• The maximum injection pressure denotes the output of the injection unit, not the resin pressure.
• The maximum injection pressure is the highest value that can be set on the machine.
  The value may be limited, depending on the molding conditions.
• The maximum injection rate in the table is the estimated value that was derived from a formula,
  and it is not guaranteed value at the maximum injection pressure.
• The clamping force on the table may be lower when a mold smaller than the indicated minimum mold size is used.
• The specifications are subject to change without notice due to performance upgrades.
• 1MPa=10.2kgf/cm2≒10kgf/cm2, 1kN=0.102tf≒0.1tf