◆Performance specifications

	Screw diameter		mm	A 19	B 22	A 22	B 22	BB 28
Models				NEX50
Specification item			Unit	3E		5E(Standard)
Injection	Screw diameter		mm	A 19	B 22	A 22	B 22	BB 28
	Injection capacity		cm3	23	35	35	35	57
	Plasticization capacity(PS)		kg/h	11	16	16	16	32
	Max. injection pressure		MPa [kgf/cm2]	255 [2600]	210 [2140]	255 [2600]	210 [2140]	169 [1725]
	Max. injection pressure		MPa [kgf/cm2]	255 [2600]	210 [2140]	255 [2600]	210 [2140]	169 [1725]
	Injection rate	Standard	cm3/s	142	190	190	265	308
		High velocity	cm3/s			190	265	308
		High load	cm3/s			133	186	216
	Injection velocity	Standard	mm/s	500		500		500
		High velocity	mm/s			500		500
		High load	mm/s			350		350
	Screw velocity		rpm	0～350		0～350		0～350
	Hopper capacity(Optional)		L	15		15		15
Clamping	Clamping force		kN[tf]	490[50]		490[50]		490[50]
	Clamping stroke		mm	250		250		250
	Mold thickness(min.-max.)		mm	170～360		170～360		170～360
	Max. daylight opening		mm	610		610		610
	Tie bar clearance(HxV)		mm	360x360		360x360		360x360
	Die plate dimensions(HxV)		mm	505x505		505x505		505x505
	Min. mold dimensions(HxV)		mm	255x255		255x255		255x255
	Locating ring diameter		mm	100		100		100
	Ejector stroke		mm	70		70		70
Others	Heater band capacity		kW	4.48	4.96	4.96	5.73	6.16
	Machine dimensions(LxWxH)		m	3.40x1.05x 1.60	3.43x1.05x 1.60	3.43x1.05x 1.60	3.52x1.05x 1.60	3.56x1.05x 1.60
	Floor dimensions(LxW)		m	3.09x0.72		3.09x0.72
	Machine weight		t	2.6		2.6

Actual plasticizing capacity may vary, depending on the molding conditions and material used.
The maximum injection pressure denotes the output of the injection unit, not the resin pressure.
The maximum injection pressure is the highest value that can be set on the machine.
The value may be limited, depending on the molding conditions.
The maximum injection rate in the table is the estimated value that was derived from a formula,
and it is not guaranteed value at the maximum injection pressure.
The clamping force on the table may be lower when a mold smaller than the indicated minimum mold size is used.
The specifications are subject to change without notice due to performance upgrades.
1MPa=10.2kgf/cm2≒10kgf/cm2, 1kN=0.102tf≒0.1tf