◆Performance specifications
| Models | NEX460 | ||||||
| Specification item | Unit | 140LE(Standard) | 210LE★ | ||||
| Injection | Screw diameter | mm | A 63 |
B 56 |
A 80 |
B 90 |
|
|---|---|---|---|---|---|---|---|
| Injection capacity | cm3 | 1107 | 776 | 2111 | 2672 | ||
| Plasticization capacity(PS) | kg/h | 209 | 156 | 277 | 375 | ||
| Max. injection pressure | MPa [kgf/cm2] |
201 [2050] |
199 [2030] |
186 [1900] |
147 [1500] |
||
| Injection rate | Standard | cm3/s | 499 | 394 | 804 | 1080 | |
| High velocity | cm3/s | - | - | - | - | ||
| High load | cm3/s | - | - | - | - | ||
| Injection velocity | Standard | mm/s | 160 | 160 | |||
| High velocity | mm/s | - | - | ||||
| High load | mm/s | - | - | ||||
| Screw velocity | rpm | 0～250 | 0～210 | 0～160 | |||
| Hopper capacity(Optional) | L | 90 | 90 | ||||
| Clamping | Clamping force | kN[tf] | 4510[460] | 4510[460] | |||
| Clamping stroke | mm | 800 | 800 | ||||
| Mold thickness(min.-max.) | mm | 375～770 | 375～770 | ||||
| Max. daylight opening | mm | 1570 | 1570 | ||||
| Tie bar clearance(HxV) | mm | 820x820 | 820x820 | ||||
| Die plate dimensions(HxV) | mm | 1190x1190 | 1190x1190 | ||||
| Min. mold dimensions(HxV) | mm | 580x580 | 580x580 | ||||
| Locating ring diameter | mm | 150 | 150 | ||||
| Ejector stroke | mm | 160 | 160 | ||||
| Others | Heater band capacity | kW | 31.5 | 39.6 | |||
| Machine dimensions(LxWxH) | m | 8.00x1.96 x2.30 |
8.83x2.14 x2.30 |
||||
| Floor dimensions(LxW) | m | 7.35x1.53 | 8.16x1.53 | ||||
| Machine weight | t | 26.2 | 27.6 | ||||
- Actual plasticizing capacity may vary, depending on the molding conditions and material used.
- The maximum injection pressure denotes the output of the injection unit, not the resin pressure.
- The maximum injection pressure is the highest value that can be set on the machine.
The value may be limited, depending on the molding conditions. - The maximum injection rate in the table is the estimated value that was derived from a formula,
and it is not guaranteed value at the maximum injection pressure. - The clamping force on the table may be lower when a mold smaller than the indicated minimum mold size is used.
- The specifications are subject to change without notice due to performance upgrades.
- 1MPa=10.2kgf/cm2≒10kgf/cm2, 1kN=0.102tf≒0.1tf
- The delivery time for ★ specifications may take longer. Contact us for more details.