◆Performance specifications

Models				NEX360
Specification item			Unit	100LE(Standard)			140LE
Injection	Screw diameter		mm	AA 50	A 56	B 63	A 63	B 71

	Injection capacity		cm3	550	776	982	1107	1406
	Plasticization capacity(PS)		kg/h	115	156	209	209	246
	Max. injection pressure		MPa [kgf/cm2]	249 [2540]	199 [2030]	157 [1600]	201 [2050]	158 [1610]

	Injection rate	Standard	cm3/s	314	394	499	499	633
		High velocity	cm3/s	393	493	623	-	-
		High load	cm3/s	314	394	499	-	-
	Injection velocity	Standard	mm/s	160			160
		High velocity	mm/s	200			-

		High load	mm/s	160			-
	Screw velocity		rpm	0～250			0～250	0～210
	Hopper capacity(Optional)		L	90			90
Clamping	Clamping force		kN[tf]	3530[360]			3530[360]
	Clamping stroke		mm	650			650
	Mold thickness(min.-max.)		mm	350～690			350～690
	Max. daylight opening		mm	1340			1340
	Tie bar clearance(HxV)		mm	735x735			735x735
	Die plate dimensions(HxV)		mm	1055x1055			1055x1055
	Min. mold dimensions(HxV)		mm	520x520			520x520
	Locating ring diameter		mm	120			120
	Ejector stroke		mm	150			150
Others	Heater band capacity		kW	17.53	22.17		31.5
	Machine dimensions(LxWxH)		m	6.81x1.74 x2.10	6.97x1.74 x2.10		7.33x1.78 x2.21
	Floor dimensions(LxW)		m	6.19x1.24			6.86x1.24
	Machine weight		t	16.0			18.5

Actual plasticizing capacity may vary, depending on the molding conditions and material used.
The maximum injection pressure denotes the output of the injection unit, not the resin pressure.
The maximum injection pressure is the highest value that can be set on the machine.
The value may be limited, depending on the molding conditions.
The maximum injection rate in the table is the estimated value that was derived from a formula,
and it is not guaranteed value at the maximum injection pressure.
The clamping force on the table may be lower when a mold smaller than the indicated minimum mold size is used.
The specifications are subject to change without notice due to performance upgrades.
1MPa=10.2kgf/cm2≒10kgf/cm2, 1kN=0.102tf≒0.1tf