◆Performance specifications

Models				NEX280
Specification item			Unit	71E(Standard)			100LE
Injection	Screw diameter		mm	AA 50	A 56	B 63	AA 50	A 56	B 63

	Injection capacity		cm3	442	554	701	550	776	982
	Plasticization capacity(PS)		kg/h	115	156	209	115	156	209
	Max. injection pressure		MPa [kgf/cm2]	249 [2540]	199 [2030]	157 [1600]	249 [2540]	199 [2030]	157 [1600]

	Injection rate	Standard	cm3/s	314	394	499	314	394	499
		High velocity	cm3/s	393	493	623	393	493	623
		High load	cm3/s	314	394	499	314	394	499
	Injection velocity	Standard	mm/s	160			160
		High velocity	mm/s	200			200

		High load	mm/s	160			160
	Screw velocity		rpm	0～250			0～250
	Hopper capacity(Optional)		L	90			90
Clamping	Clamping force		kN[tf]	2740[280]			2740[280]
	Clamping stroke		mm	600			600
	Mold thickness(min.-max.)		mm	320～610			320～610
	Max. daylight opening		mm	1210			1210
	Tie bar clearance(HxV)		mm	660x660			660x660
	Die plate dimensions(HxV)		mm	955x955			955x955
	Min. mold dimensions(HxV)		mm	465x465			465x465
	Locating ring diameter		mm	120			120
	Ejector stroke		mm	130			130
Others	Heater band capacity		kW	17.74	21.98		17.53	22.17
	Machine dimensions(LxWxH)		m	6.41x1.62 x2.10	6.60x1.62 x2.10		6.57x1.62 x2.10	6.72x1.62 x2.10
	Floor dimensions(LxW)		m	5.99x1.18			5.99x1.18
	Machine weight		t	14.5			14.8

Actual plasticizing capacity may vary, depending on the molding conditions and material used.
The maximum injection pressure denotes the output of the injection unit, not the resin pressure.
The maximum injection pressure is the highest value that can be set on the machine.
The value may be limited, depending on the molding conditions.
The maximum injection rate in the table is the estimated value that was derived from a formula,
and it is not guaranteed value at the maximum injection pressure.
The clamping force on the table may be lower when a mold smaller than the indicated minimum mold size is used.
The specifications are subject to change without notice due to performance upgrades.
1MPa=10.2kgf/cm2≒10kgf/cm2, 1kN=0.102tf≒0.1tf