◆Performance specifications

Models				NEX180
Specification item			Unit	18E			25E(Standard)			36E(Standard)
Injection	Screw diameter		mm	AA 32	A 36	B 40	AA 36	A 40	B 45	AA 40	A 45	B 50

	Injection capacity		cm3	117	148	182	163	201	254	226	286	353
	Plasticization capacity(PS)		kg/h	40	54	75	54	75	102	62	91	115
	Max. injection pressure		MPa [kgf/cm2]	265 [2700]	218 [2220]	176 [1800]	255 [2600]	211 [2150]	167 [1705]	245 [2500]	206 [2100]	167 [1705]

	Injection rate	Standard	cm3/s	161	204	251	178	220	278	220	278	344
		High velocity	cm3/s	201	255	314	254	314	398	314	398	491
		High load	cm3/s	161	204	251	183	226	286	226	286	353
	Injection velocity	Standard	mm/s	200			175			175
		High velocity	mm/s				250			250
				250
		High load	mm/s	200			180			180
	Screw velocity		rpm	0～300			0～300			0～250
	Hopper capacity(Optional)		L	25			45			45
Clamping	Clamping force		kN[tf]	1765[180]			1765[180]			1765[180]
	Clamping stroke		mm	450			450			450
	Mold thickness(min.-max.)		mm	250～510			250～510			250～510
	Max. daylight opening		mm	960			960			960
	Tie bar clearance(HxV)		mm	560x560			560x560			560x560
	Die plate dimensions(HxV)		mm	800x800			800x800			800x800
	Min. mold dimensions(HxV)		mm	395x395			395x395			395x395
	Locating ring diameter		mm	120			120			120
	Ejector stroke		mm	110			110			110
Others	Heater band capacity		kW	8.88	10.57		10.54	13.01		12.53	15.53
	Machine dimensions(LxWxH)		m	5.37x1.37 x2.00			5.37x1.37 x2.00	5.42x1.37 x2.00		5.58x1.37 x2.00	5.68x1.37 x2.00
	Floor dimensions(LxW)		m	4.85x0.96			4.85x0.96			4.85x0.96
	Machine weight		t	7.0			7.6			7.9

Actual plasticizing capacity may vary, depending on the molding conditions and material used.
The maximum injection pressure denotes the output of the injection unit, not the resin pressure.
The maximum injection pressure is the highest value that can be set on the machine.
The value may be limited, depending on the molding conditions.
The maximum injection rate in the table is the estimated value that was derived from a formula,
and it is not guaranteed value at the maximum injection pressure.
The clamping force on the table may be lower when a mold smaller than the indicated minimum mold size is used.
The specifications are subject to change without notice due to performance upgrades.
1MPa=10.2kgf/cm2≒10kgf/cm2, 1kN=0.102tf≒0.1tf