◆Performance specifications

	Screw diameter		mm	A 16	B 19
Models				NEX15
Specification item			Unit	1E(Standard)
Injection	Screw diameter		mm	A 16	B 19
	Injection capacity		cm3	10	16
	Plasticization capacity(PS)		kg/h	8	13
	Max. injection pressure		MPa [kgf/cm2]	255 [2600]	196 [2000]
	Max. injection pressure		MPa [kgf/cm2]	255 [2600]	196 [2000]
	Injection rate	Standard	cm3/s	101	142
		High velocity	cm3/s	101	142
		High load	cm3/s	70	99
	Injection velocity	Standard	mm/s	500
		High velocity	mm/s	500
		High load	mm/s	350
	Screw velocity		rpm	0～400
	Hopper capacity(Optional)		L	15
Clamping	Clamping force		kN[tf]	147[15]
	Clamping stroke		mm	160
	Mold thickness(min.-max.)		mm	130～260
	Max. daylight opening		mm	420
	Tie bar clearance(HxV)		mm	260x260
	Die plate dimensions(HxV)		mm	370x370
	Min. mold dimensions(HxV)		mm	180x180
	Locating ring diameter		mm	60
	Ejector stroke		mm	50
Others	Heater band capacity		kW	2.95	3.16
	Machine dimensions(LxWxH)		m	2.50x0.86x1.46
	Floor dimensions(LxW)		m	2.25x0.66
	Machine weight		t	1.7

Actual plasticizing capacity may vary, depending on the molding conditions and material used.
The maximum injection pressure denotes the output of the injection unit, not the resin pressure.
The maximum injection pressure is the highest value that can be set on the machine.
The value may be limited, depending on the molding conditions.
The maximum injection rate in the table is the estimated value that was derived from a formula,
and it is not guaranteed value at the maximum injection pressure.
The clamping force on the table may be lower when a mold smaller than the indicated minimum mold size is used.
The specifications are subject to change without notice due to performance upgrades.
1MPa=10.2kgf/cm2≒10kgf/cm2, 1kN=0.102tf≒0.1tf
Selecting 14mm screw for NEX15 is available. Please contact us for more details.
For more details on NEX15, please refer to the NEX15 catalog.