◆Performance specifications

Models				NEX140
Specification item			Unit	12E			18E(Standard)			25E
Injection	Screw diameter		mm	AA 28	A 32	B 36	AA 32	A 36	B 40	AA 36	A 40	B 45

	Injection capacity		cm3	77	101	127	117	148	182	163	201	254
	Plasticization capacity(PS)		kg/h	28	40	54	40	54	75	53	75	102
	Max. injection pressure		MPa [kgf/cm2]	265 [2700]	223 [2280]	176 [1800]	265 [2700]	218 [2220]	176 [1800]	255 [2600]	211 [2150]	167 [1705]

	Injection rate	Standard	cm3/s	166	217	275	161	204	251	178	220	278
		High velocity	cm3/s				201	255	314	254	314	398
		High load	cm3/s	135	177	224	161	204	251	183	226	286
	Injection velocity	Standard	mm/s	270			200			175
		High velocity	mm/s				250			250

		High load	mm/s	220			200			180
	Screw velocity		rpm	0～300			0～300			0～300
	Hopper capacity(Optional)		L	25			25			45
Clamping	Clamping force		kN[tf]	1373[140]			1373[140]			1373[140]
	Clamping stroke		mm	400			400			400
	Mold thickness(min.-max.)		mm	220～450			220～450			220～450
	Max. daylight opening		mm	850			850			850
	Tie bar clearance(HxV)		mm	510x460			510x460			510x460
	Die plate dimensions(HxV)		mm	720x670			720x670			720x670
	Min. mold dimensions(HxV)		mm	325x325			325x325			325x325
	Locating ring diameter		mm	120			120			120
	Ejector stroke		mm	110			110			110
Others	Heater band capacity		kW	7.98	9.13		8.88	10.57		10.54	13.01
	Machine dimensions(LxWxH)		m	4.74x1.32 x2.00			4.76x1.32 x2.00	4.93x1.32 x2.00		4.86x1.32 x2.00	5.05x1.32 x2.00
	Floor dimensions(LxW)		m	4.37x0.93			4.37x0.93			4.37x0.93
	Machine weight		t	6.1			6.3			6.9

Actual plasticizing capacity may vary, depending on the molding conditions and material used.
The maximum injection pressure denotes the output of the injection unit, not the resin pressure.
The maximum injection pressure is the highest value that can be set on the machine.
The value may be limited, depending on the molding conditions.
The maximum injection rate in the table is the estimated value that was derived from a formula,
and it is not guaranteed value at the maximum injection pressure.
The clamping force on the table may be lower when a mold smaller than the indicated minimum mold size is used.
The specifications are subject to change without notice due to performance upgrades.
1MPa=10.2kgf/cm2≒10kgf/cm2, 1kN=0.102tf≒0.1tf